Perforated heating foil fleece-laminated
The heating foil offered here is the thinnest heating source for use as floor, wall or ceiling heating. It consists of two copper strips which supply an electrically conductive coating on a carrier material. In addition, the heat source is laminated, covered with fleece and perforated. Almost the entire surface within the heating foil heats up evenly and thus provides pleasant warmth over the entire laid surface. The energy used is converted into infrared rays, almost without loss, which makes the heating system so high-quality and efficient.
Because the material is so thin, the perforation and the fleece lamination, the panel heating can be installed effortlessly under existing floor coverings, on walls or ceilings.
The infrared heating foil is well suited for use as electric floor heating and where a higher temperature is desired. This can be in the living room, bedroom, in front of the sofa or under the dining table.
- -Perforated and fleece-laminated - facilitates application
- -Direct healthy and pleasant radiant heat
- -Low installation height and weight, space-saving
- -Easy, quick and safe installation
- -Uniform surface temperature
- -Flexible, robust and reliable
- -Reduced mould formation
- -Very high energy efficiency
- -Anti-allergic room climate
- -Low acquisition costs
- -Homogeneous energy distribution
- -Made in Germany
Operating voltage: 36 volts
Max. power consumption: 80Watt/m² +/-10%
Heating surface per m²: 82
Path width: 90cm
Active area: 85cm
IR wavelength: 7-14 microns
Temperature resistance: up to 100°C
Max. Web length: 5 metres in one piece
Can be shortened: Yes, as required
Material thickness: 0.4mm
Insulation: 4-layer, 1-fold insulation
When using electric underfloor heating, a thermostat that allows an adjustable temperature limit of 26°C must be used for control.
When using electric heating elements, ensure that the surface covering has the appropriate thermal conductivity.
A manufacturer's approval must be obtained in advance by the customer.
The installation of electrical heating systems may and must only be carried out by a specialist in accordance with VDE DIN 100.
Heating foil wattage and its use:
Vinyl = 60-80 watts/m²
Laminate/parquet = 60 - 130 watts/m²
Wall/ceiling and individual projects = 160 - 220 watt/m²