Digital Thermostat Control for Underfloor Heating
Heatit Z-Wave is an thermostat for electric floor heating.
A built-in Z-Wave chip ensures that this thermostat can be connected with all Z-Wave compatible Home Automation systems. Z-Wave is the international wireless protocol for communication in the Smart Home.
Thanks to Z-Wave, products from different manufacturers can be used together in a wireless network. Thus, this product can be used with any other products from other manufacturers in a common Z-Wave radio network. Heatit Z-Wave is equipped with a single pole switch and fits into System 55 frames.
Z-Wave ensures a reliable communication by reconfirming every message (two-way communication) and every mains powered node can act as a repeater for other nodes (meshed network) in case the receiver is not in direct wireless range of the transmitter.
The thermostat can withstand a load of max 16A / 3600W at 230V. At higher loads the thermostat must control a contactor. The thermostat can be connected to two external sensors. The thermostat has the capacity of up to 8 associations (relays, wall plugs etc.)
Z-Wave Plus chip, 500 series
Weekly program via gateway
Setback mode via gateway or pilot wire
Can be used in connection with different NTC-sensors
Lock mode/child lock
Some of these functions are available when in use with a Z-Wave Smart Central
Suitable for switch series with an opening of 55x55mm, such as
- Berker (S.1, B.1, B.3, B.7 glass)
- GIRA (System 55, Standard 55, E2, E22, Event, Esprit)
- Merten (1-M, Atelier-M, M-Smart, M-Arc, M-Star, M-Plan)
- JUNG (A 500, AS 500, A plus, A creation)
- ELSO (Joy)
Installation Type: flush-mounted
Protocol: Z-Wave - 868,4Mhz
Chip: Z-Wave 500 chip
Rated Voltage 230V 50/60Hz
Max load: 16A / 3600W (resistive load); 750W self-limiting heating cable
Max operating temp.: 5 bis 40°C
Sensor: Internal & External
Temperature control range (internal): 5-40 ° C (room sensor)
Temperature control range (external): 5-40 ° C (floor sensor)
Hysteresis: 0,3°C - 3,0°C (default 0,5°C)
Switch: Single-pole switch
Compatible: with NTC sensors with values 10, 12, 15, 22, 33 and 47 kO @ 25°C
IP Protection: IP 21
Approvals: Z-Wave Plus; EN 60730-1, EN 60730-2-9; EMC 2014/30/EU, RoHS 2011/65/EU; LVD 2014/35/EU
Dimensions: 49.5x49.5x51.1mm WxHxD (depth in wall: 22mm)
1x Heatit Z-Wave Thermostat
1x Floor sensor
1x Instruction manual
To control the thermostat via an app or Internet browser, a Z-Wave enabled Smarthome center is required. (please verify the compatiblity before)
The thermostat can alternatively be set and operated without a Z-Wave control panel via the device itself.